Keyboard Stand Assembly

CAUTION
Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accordance with the sequence given below.

Assembly should be carried out by at least two persons.

Be sure to use the correct screw size, as indicated above. Use of incorrect screws can cause damage.

Be sure to tighten up all screws upon completing assembly of each unit.

To disassemble, reverse the assembly sequence given below.

Have a Phillips-head (plus ) screwdriver ready.

The parts shown in the "Assembly Parts" illustration will be used. Follow the assembly instructions and select the parts as needed.


Assembly Parts

(Figure)
Back board
Side boards
Stand bases
(1)	6 x 70 mm round head screws (4 pcs.)
(2)	Joint connectors (4 pcs.)
(3)	3.5 x 16 mm tapping screws (12 pcs.)
(4)	6 x 30 mm round head screws (4 pcs.)
(5)	5 x 16 mm round head screws (4 pcs.)
(6)	Angle brackets (4 pcs.)



1.	Attach the stand bases.
Making sure that the boards are facing the proper direction (the holes should face inside), insert the joint connectors (2) into the holes as shown.  The joint connectors have been installed properly if you can see a plus mark on the connector.
Attach the stand bases to the rear of the side boards, using the 6 x 70 mm round head screws (1).
(Figure)
Fig. 1
(2)	Joint connectors
(1)	6 x 70 mm round head screws


2.	Attach the angle brackets.
Attach the angle brackets (6) to the side boards using the 3.5 x 16 mm tapping screws (3).
(Figure)
Fig. 2
(6)	Angle brackets
(3)	3.5 x 16 mm tapping screws


3.	Attach the back board.
Attach the back board, using the 6 x 30 mm round head screws (4).

CAUTION
Be careful not to drop the back board or touch the sharp metal fittings.
(Figure)
Fig. 3
(4)	6 x 30 mm round head screws


4.	Put the keyboard on the stand.
Carefully place the keyboard on the side boards.
Slowly move the keyboard so that the holes on the bottom of the keyboard are properly aligned with the holes on the angle brackets.

CAUTION
Be careful not to drop the keyboard or to get your fingers caught between the keyboard and the stand parts.


5.	Install the keyboard to the stand.
Fix the keyboard to the angle brackets, using the 5 x 16 mm round head screws (5).
(Figure)
Fig. 5
(5)	5 x 16 mm round head screws


Post-assembly checklist
Once you've assembled the stand, check the following points:

Are there any parts left over?
->	If so, sread the assembly instructions again and correct any errors you might have made.

Is the instrument clear of doors and other movable fixtures?
->	If not, move the instrument to an appropriate location.

Does the instrument make a rattling noise when you play it or move it?
->	If so, properly tighten all screws.

Also, if the keyboard makes a creaking noise or seems unsteady when you play it, refer carefully to the assembly instructions and diagrams and retighten all screws.

This is the end of the file.