The Dual Mode

The dual mode makes it possible to play two voices simultaneously across the entire range of the keyboard. 

To activate the dual mode simply press two voice selectors at the same time (or press one voice selector while holding another). The voice indicators of both selected voices will light when the dual mode is active. To return to the normal single-voice play mode, press any single voice selector.
According to the voice numbering priority as shown in the diagram on the left, lower valued voice numbers will be designated as the 1st Voice (the other voice will be designated as the 2nd Voice).

(Figure)
Voice numbering priority

NOTE
[EFFECT] in the Dual Mode
Depending upon the conditions one effect type will take priority over the other. Depth will be decided according to the depth default value of the voice combination. However, using function F3 (see page 28) you can change the depth value for each voice as you like.
Effect depth setting via the panel controls (i.e. pressing the [minus/NO] or 
[plus/YES] buttons while holding the [EFFECT] button -- see page 19) will be applied to the 1st Voice only.
[REVERB] in the Dual Mode
The reverb type assigned to the 1st Voice will take priority over the other. (If the reverb is set to OFF, the 2nd Voice's reverb type will be in affect.) 
Reverb depth setting via the panel controls (i.e. pressing the [minus/NO] or [plus/YES] buttons while holding the [REVERB] button -- see page 18) will be applied to the 1st Voice only.

Other Dual Mode Functions
The YPP-100 Function mode provides access to a number of other dual-mode functions, listed below. See the corresponding pages for details.

Dual Balance	28
Dual Detune	28
1st Voice Octave Shift	28
2nd Voice Octave Shift	28
1st Voice Effect Depth	29
2nd Voice Effect Depth	29
Reset	29

This is the end of the file.